标题: [转]HOWTO: Setting up the USB blaster on Ubuntu 9.04 (Jaunty Jackalope) [打印本页] 作者: liyongjie 时间: 2010-4-26 21:44 标题: [转]HOWTO: Setting up the USB blaster on Ubuntu 9.04 (Jaunty Jackalope) I just spent a couple hours figuring this out, so I thought I'd post it here for everyone else. To use the USB blaster to program Altera parts on Linux, you need to do a bit of work to configure your machine to give Quartus access to it. Unfortunately though, Altera does not provide instructions for how to do this for Ubuntu. So I've put together instructions for Ubuntu 9.04 (Jaunty Jackalope). They may also work for slightly older/newer versions of Ubuntu.
Step 1: Set-up "usbfs" emulation (see Ubuntu bug #156085 for the history behind this, if you're curious)
1) Open /etc/init.d/mountdevsubfs.sh as root ("sudo gedit /etc/init.d/mountdevsubfs.sh" from a terminal)
2) Scroll down to the part that reads "domount devpts ..."
3) Add this after that line:
Code:
#
# Magic to make /proc/bus/usb work
#
mkdir -p /dev/bus/usb/.usbfs
domount usbfs "" /dev/bus/usb/.usbfs usbfs -obusmode=0700,devmode=0600,listmode=0644
ln -sf .usbfs/devices /dev/bus/usb/devices
mount --rbind /dev/bus/usb /proc/bus/usb
4) Save and close.
5) Run "sudo /etc/init.d/mountdevsubfs.sh start"
Step 2: Tell Ubuntu to let normal users use the USB blaster
1) Create a new file at /etc/udev/rules.d/51-usbblaster.rules ("sudo gedit /etc/udev/rules.d/51-usbblaster.rules")
2) Put this in it:
Code:
# Altera USB-Blaster rule to set mode to 666.
SUBSYSTEM=="usb", ENV{DEVTYPE}=="usb_device", SYSFS{idVendor}=="09fb", SYSFS{idProduct}=="6001", MODE="0666", NAME="bus/usb/$env{BUSNUM}/$env{DEVNUM}", RUN+="/bin/chmod 0666 %c"
3) Save and close.
4) Run "sudo udevadm control --reload-rules".
It's now configured! Connect your USB blaster (or remove and reconnect if it's already in) and then launch Quartus. It should now be selectable in Tools -> Programmer -> Hardware Setup.作者: liyongjie 时间: 2010-4-27 08:48
Ubuntu 更高版本的也有哦，希望大家发现！