标题: 求助Timestamp value does not match:怎麼解決? [打印本页] 作者: kevinchan 时间: 2009-6-3 09:50 标题: 求助Timestamp value does not match:怎麼解決? 使用DE2的板子,軟體build完後,run的時候就跑出這個訊息,
不知各位大大有沒有遇過這類的問題,
大概是發生了什麼狀況? 要怎麼解決呢?? 謝謝!
Using cable "USB-Blaster [USB-0]", device 1, instance 0x00
Pausing target processor: OK
Reading System ID at address 0x018010B8:
ID value does not match: read 0xFFFFFFFF; expected 0x094D4644
Timestamp value does not match: image on board is older than expected
Read timestamp 7:59:59 1970/01/01; expected 20:40:15 2009/06/01
The software you are downloading may not run on the system which is currently
configured into the device. Please download the correct SOF or recompile.
Restarting target processor作者: Frank 时间: 2009-6-3 12:07
检查一下你的PC的系统时钟作者: kevinchan 时间: 2009-6-3 18:08
檢了一下系統時間,是正確吔~作者: Frank 时间: 2009-6-8 15:18
那就是你的硬件和程序不匹配。作者: rich 时间: 2009-6-8 15:36
Please make sure the assocaited .sof is download bebfore you download the nios program.作者: dwcc 时间: 2009-7-14 16:32
我的方法比較呆，不過每次都能成功喔，就是清空所有檔案然後再從頭到尾重新編譯，屢試不爽。作者: xlbian 时间: 2009-7-30 21:58
